Trinity Forge, Inc.Go to Trinity Forge Home

TOP-QCTRL: Quality Control


Trinity Forge carefully controls the quality of incoming material as part of our Resource Management Process (see TOP-RMGMT), then controls the quality of product at all stages of the Order Fulfillment process (see TOP-PRODN)

Below, in general order of occurrence, the quality control activities are outlined showing the primary Trinity Operating Procedure (TOP) associated with each activity.

1. Quality control of raw materials.

  • Inspection of incoming bar stock. See TOP-RECRM
  • Inspection of other incoming materials. See TOP-RECOM

2. Quality control during production.

  • Quality control steps prior to forging. See TOP-PREQC
  • Quality control steps directly associated with forging. See TOP-PROQC
  • Quality control steps after forging, including 100% visual inspection and final inspection AQL of entire lot. See TOP-POSQC
  • Quality control steps associated with machining. See TOP-MOPQC

3. Control of nonconformance.

Our quality control activities depend heavily upon our measuring instrument management activities. See Section 6 of TOP-RMGMT

Please be aware that quality control is only one aspect of Trinity Forge’s quality system. For a look at the full system see Trinity Forge Quality Manual.

For information on a document or record, including definition, primary responsibility and retention, refer to the Document and Record Master List.

See an uncontrolled translation of this page in the language of your choice:

Search this web site or the entire web:

Search WWW Search

Documents are controlled only when viewed on-line in the original English -- printed copies or translations are not controlled documents.
© 2008 Trinity Forge, Inc., +1 817-473-1515